Stepover

[joe]

That techniques came about my desire to bring more interest to the lettering. This was a project with back lighting. The letters ended up being about 23" in height.

[dldalley]

I am trying to make a cut with multiple passes WITHOUT a step over. After reading the prior question, the program should ignore the stepover however it does not. It is stepping over to the outside when I am trying to cut the inside. What am I doing wrong?

[gundog]

I am trying to make a cut with multiple passes WITHOUT a step over. After reading the prior question, the program should ignore the stepover however it does not. It is stepping over to the outside when I am trying to cut the inside. What am I doing wrong?

Check the drawing and make sure it is a closed vector you can right click on the vector and if you get the choice to close it by moving end points or with a straight line it is open you can also look at the nodes in node edit mode. I suspect your vector is open and that is why this is happening.

Mike

[Jerry Carney]

Joe is always creative.