Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: After 10 minutes my Y axis wont move

  1. 09-02-2016, 09:22 PM #11
    Barnabyriver
    Barnabyriver is offline New Member
    Join Date
    Mar 2011
    Location
    southwestern ontario Canada
    Posts
    15

    Default

    Yes everything is clean and cool still having the same problem!
    Reply With Quote Reply With Quote
  2. 11-08-2016, 02:41 PM #12
    Barnabyriver
    Barnabyriver is offline New Member
    Join Date
    Mar 2011
    Location
    southwestern ontario Canada
    Posts
    15

    Default

    After closer examination the control board had some burnt spots likely caused when the machine was moved. thanks to shopbot tech support im back up and running with a replacement board!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. move 5-axis to a place with access constraints
    By sebastian in forum Assembly & Maintenance
    Replies: 2
    Last Post: 01-06-2015, 11:40 AM
  2. Move & Jog not working properly, Move is too fast and jog is too slow!
    By Nilloc in forum Troubleshooting
    Replies: 8
    Last Post: 06-10-2014, 03:49 PM
  3. Vac motor failed in first 20 minutes?
    By tim_mcknight in forum ShopBotter Message Board
    Replies: 8
    Last Post: 11-02-2010, 03:14 PM
  4. Control Software Coordinates Move, The Machine Does Nit Move
    By zeke in forum Troubleshooting
    Replies: 5
    Last Post: 06-07-2009, 07:23 PM
  5. ShopBot stops after 30 minutes
    By chip1 in forum Archives-2002
    Replies: 17
    Last Post: 11-06-2002, 02:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules