I found this thread just exactly what I needed to read after a PC and SB3 software update. I'm still having problems with my Z axis being wrong though. When I run a C2 and zero with my plate, it thinks its at 1.0" in the control software, but when I put a tape measure on it, it's only sitting at about .375". Initial thoughts were that maybe I have a variable set wrong somewhere? I have Vexta stepper motors. Model ASM911AA on both my x and y axis' and a model ASM98AA-T10 motor on my Z axis.
Anyone have a similar issue after a PC and software update?
Nate Sirek
Operations Manager;
Shop Fabrication Manager
House Partners Inc.
West Saint Paul, MN
Shopbot 48 x 96 PRT Alpha
220v 18000 RPM HSD Spindle
4 Zone Vacuum Table, 7hp Spencer Re-Gen Blower
Cabinet Parts Pro
10 Years Experience in a cabinet and counter top fabrication shop. CNC Newbie.