Page 2 of 2 FirstFirst 12
Results 11 to 11 of 11

Thread: Square leg

  1. #11
    Join Date
    Sep 2006
    Garland Tx


    It’s only necessary to cut the finish pass with a ball nose. Since you are cutting with a very small stepover, some brave souls don’t do a rough cut at all. This works out ok IF you survive the first pass! That’s an improvement that could be made to the program… step down the first pass! In the case of my very large molding, my tapered bit only has a 1” length of cut but the first finish pass is 2” deep. I’ll have to do some clearance cutting.

    I’ve attached a SketchUp rendering of my idea for cutting the legs from square blanks.
    Attached Images Attached Images

Similar Threads

  1. How to square
    By kubotaman in forum Indexer
    Replies: 11
    Last Post: 06-02-2010, 02:08 AM
  2. Square, uh - not square?
    By silverlaker in forum Troubleshooting
    Replies: 11
    Last Post: 01-15-2010, 10:03 AM
  3. Square Z
    By gpari in forum Archives2007
    Replies: 3
    Last Post: 04-06-2007, 07:46 PM
  4. How to square the Z
    By harryball in forum Archives2006
    Replies: 7
    Last Post: 09-22-2006, 08:02 AM
  5. Square Enough?...
    By in forum Archives2003
    Replies: 4
    Last Post: 09-06-2003, 10:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts