When I draw out the off fall in the ShopBot Link I have to draw it starting in the lower left of the table shown which is x=96, y=48. That is point one (P1) in the screen shot below.
If I do it that way then when I do my nest the off fall is orientated in the lower left of the nesting diagram which corresponds with the 0,0 point of my machine.
What am I doing wrong? When I draw point one in the off fall screen at 0,0 then I would have to put the piece at 96,48 on my machine. Everything is backwards. I'm sure there is a simple explanation, some button that I haven't pressed, but I can't figure it out.
I'd appreciate any help. Thanks.