Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Corian Cut to size

  1. #11
    Join Date
    Feb 2013
    Location
    River Fall WI
    Posts
    731

    Default

    Will get some pictures up sometime this week.
    Kyle Stapleton
    River Falls Renaissance Academy
    Math/Technology Education Teacher


    PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
    Desktop w/spindle
    Potter Pen
    Aspire 8.5, Creo 3.0

  2. #12
    Join Date
    Feb 2013
    Location
    River Fall WI
    Posts
    731

    Default

    Here are some pictures
    Attached Images Attached Images
    Kyle Stapleton
    River Falls Renaissance Academy
    Math/Technology Education Teacher


    PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
    Desktop w/spindle
    Potter Pen
    Aspire 8.5, Creo 3.0

Similar Threads

  1. SB3 'Material Size' different than Aspire 8.5 'Job Size and Position, how to fix?
    By carolinasmith in forum ShopBot Control Software v3
    Replies: 5
    Last Post: 10-06-2016, 08:35 PM
  2. Drawing size does not match cut size.
    By tracys in forum ShopBotter Message Board
    Replies: 0
    Last Post: 09-30-2013, 01:22 PM
  3. Lying about bit size to affect part size
    By sbd1 in forum ShopBot Control Software v3
    Replies: 13
    Last Post: 06-10-2012, 02:30 PM
  4. Corian
    By gsmith in forum Techniques for Cutting, Drilling, Machining
    Replies: 3
    Last Post: 10-25-2011, 08:55 AM
  5. Cut size not equal to part wizard-toolpath size
    By bob_schroeder in forum Archives2007
    Replies: 5
    Last Post: 11-18-2007, 02:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •