Results 1 to 3 of 3

Thread: Help Re-installing PRT with Yaskawa VFD

  1. #1
    Join Date
    Nov 2006
    Location
    , Long Beach CA
    Posts
    64

    Default Help Re-installing PRT with Yaskawa VFD

    I am in the process of reinstalling my older PRT Alpha with a Yaskawa VFD and HSD spindle but I misplaced the wiring diagram for the Yaskawa.

    I left the wires connected in the controller so I assume they will be ok. It's the connections inside the VFD that I need help with.

    Any help would be greatly appreciated.

    Tom

  2. #2
    Join Date
    Aug 2008
    Location
    Western Mechanical acs, Phoenix AZ
    Posts
    22

    Default

    Hi Tom
    I have the manual for a Yaskawa V1000 and can Email you the standard connection diagram if that will help.

    Bill

  3. #3
    Join Date
    Nov 2006
    Location
    , Long Beach CA
    Posts
    64

    Default

    Hi Bill,

    I appreciate the help.

    I might have been a little quick in this post fro help. After about an hour looking through old posts I think I have the information need to wire this thing correctly. The only thing I need to do is verify that the 220 Single Phase connects to L1 and L2 (as seen on other posts). My concern is that the screw is tight on L2 and loose on L1 and L3. I would have thought that if it came off of L2 that screw would be loose.

    I'm just not sure.

    Tom

Similar Threads

  1. Yaskawa spindle won't turn on
    By Stagecraft in forum Troubleshooting
    Replies: 2
    Last Post: 02-12-2013, 05:05 PM
  2. Yaskawa DriveSetting for PRSSTANDARD
    By hykambois in forum Other
    Replies: 1
    Last Post: 03-22-2009, 08:46 PM
  3. Spindle Control Board - Yaskawa
    By jbuell in forum Archives2008
    Replies: 3
    Last Post: 08-21-2008, 10:18 PM
  4. Remote operator station for Yaskawa VFD
    By 3imoh in forum Archives2007
    Replies: 2
    Last Post: 04-20-2007, 09:46 PM
  5. Yaskawa drive
    By phil_o in forum Archives2006
    Replies: 1
    Last Post: 08-24-2006, 08:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •