Looking for 48 x 96 machine

[oneGsim]

I'm located in Seattle and looking to purchase a newer/updated 48 x 96 machine that's in good working order. Please let me know if you have one. Thanks!

[Routing4U]

Have a PRT96. Upgraded Controller has less than 3 hours use. Has been stored for approximately 3 to 4 years. Factory built for show in Las Vegas, NV. Hookup computer with routing / engraving software. Ready to use. Las Vegas, NV area (dusty but no rust). All steel. Zero plate with selection of bits. Other than a new sacrifice material ready to work.

Ron

[oneGsim]

Thank you but we have found a machine. Best, Xylon

[prrainsberry]

Have a PRT96. Upgraded Controller has less than 3 hours use. Has been stored for approximately 3 to 4 years. Factory built for show in Las Vegas, NV. Hookup computer with routing / engraving software. Ready to use. Las Vegas, NV area (dusty but no rust). All steel. Zero plate with selection of bits. Other than a new sacrifice material ready to work.

Ron

Is this still available?

[Teen Challenge]

Is this still available?