What software would I need to create a mesh design like this for the edge lit acrylic?
What software would I need to create a mesh design like this for the edge lit acrylic?
V carve pro would be all you would need even cut 2d would do it
It doesn't help with the creation, but a lot of info about doing them once the design is found on the web;
http://forum.vectric.com/viewtopic.php?f=19&t=17065
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
One of the best for that kind of thing without breaking the bank is Rhino.
What he is showing is a 2D cut just a outline no 3D is needed
It is a 2D cut, but the outline or vectors are derived from a 3D mesh of a model. Sure, you could draw it in 2D, but you would need a good 3D minds eye to design it.
Scott
Not sure if this will work or if it is still valid but you might give it a look.
http://k3dsurf.sourceforge.net/
Bill