Using the ruler, we TILE down the Y axis 16"
Careful alignment is achieved by marking each 16" segment.
With practice, one can "REGISTER" perfectly.
I would suggest a sharp pencil.
Hope this is helpful to all.
Using the ruler, we TILE down the Y axis 16"
Careful alignment is achieved by marking each 16" segment.
With practice, one can "REGISTER" perfectly.
I would suggest a sharp pencil.
Hope this is helpful to all.
Our most important shop tool is the pencil sharpener!
Great trick!
2006 PRTalpha 96x48
3hp SEV spindle
Vcarve Pro8
Always eager to consume large amounts of info, tips, and techniques!
Nice idea. I have a couple million dowl holes in my spoilboard but sometimes you cant drill holes into the piece.
Two questions:
1. Where did you get that ruler?
2. Where did you get the shopfox clamps with the hand wheels? Mine just have an allen screw, which was too short when I got them, and had to replace them.
ShopBot Desktop 24x18
Spindle
VCarve Pro 8.5xx
ScottP Super Deluxe Spoilboard
Ruler is a t-square from Lowes.
Clamps are from "Grizzly" and I put the handles on myself (borrowed from other clamps.)
Our most important shop tool is the pencil sharpener!