I wanted to carve this with a 90* bit and wasn't sure it would work. Looking at the preview in V Care Pro looked like it "might". So I took a shot. It's really marginal, and after painting and sanding I'm not sure that what is there of the serifs will still be there. Probably not likely. I was debating going back over it with a 60* bit. I need to do that with the "fire" anyway as the "points" at the tops of the flames didn't come out at all. Anyone have any other suggestions as to how to make the serifs just a little deeper/wider while keeping the 90* text before I redo it all with a 60?
The attached is the preview. I couldn't get a good picture showing the outcome since my phone refused to focous on it up close.
ShopBot Desktop 24x18
Spindle
VCarve Pro 8.5xx
ScottP Super Deluxe Spoilboard