Hello,

I have an SB 32 standard Buddy. I went to surface a piece of wood today and had the z zero off the spoilboard not the top of the wood. (Thank me very much) The surfacing bit gouged right into the wood to about 3/16" for about 2-3 inches before I could it the stop. The router stopped spinning.

When I went to run the file again the xyz worked but the router did not start up. I unplugged router and went to direct power source and it worked.

I did some search across the forum and the best I could come up with is a blown fuse or the "relay"?

Could it be anything else? What is the relay? I can't identify it on my diagram.

Angelo