Not totally happy with it.
Next time I'll use a negative Allowance on the 1mmTBN, and THEN cut with no Allowance with the .25mmTapered Ball Nose to get rid of the "Ditch"edge of the model, and eliminate the edge stepover marks on the .745" deep model edges so that it blends more with the sidewalls....Live and Learn
Also no more wet wood cutting, had to apply a stiffening coat and then cut it again at .006" deeper to eliminate wet wood "Velvet Fuzzies", which are the dickens to get rid of!!
(Parked the spindle over it and used spindle warm air to speed drying)
Good experiment though...learned a lot!
scott
Reply With Quote
