Results 1 to 3 of 3

Thread: Power supply

  1. 06-25-2017, 04:43 PM #1
    jerry_stanek
    jerry_stanek is offline Senior Member
    Join Date
    Dec 2007
    Posts
    2,392

    Default Power supply

    My stepper power supply went out but I have another from another unit but it only has the the power for the steppers. What I need to know is where to get a 24 volt unit for the spindle fan and limit switches. I am not sure how many amps I will need for them
    Reply With Quote Reply With Quote
  2. 06-25-2017, 06:05 PM #2
    Gary Campbell's Avatar
    Gary Campbell
    Gary Campbell is offline Senior Member
    Join Date
    Apr 2007
    Location
    Marquette, MI
    Posts
    3,388

    Default

    Jerry...
    Try here, there are a few to pick from: http://www.factorymation.com/Power_S...-18-to-100W_SB
    Gary Campbell
    GCnC Control
    GCnC411(at)gmail(dot)com
    Servo Controller Upgrades
    http://www.youtube.com/user/Islaww1


    "We can not solve our problems with the same level of thinking that created them"
    — Albert Einstein

    Reply With Quote Reply With Quote
  3. 06-27-2017, 12:04 PM #3
    jerry_stanek
    jerry_stanek is offline Senior Member
    Join Date
    Dec 2007
    Posts
    2,392

    Default

    I did some more testing and found out when the surge took out my board it also burned the ground wires to the bot and the ground wire to the main power and also the hot line was broken inside the plug wire. I rewired a new plug on and back up and running
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules