Member
SB Shows Axis Is Moving... But CNC Is Not
Little history, My usb control card went bad. Got a new one in the mail today. Now when I go to "move" It shows in the software the basic is moving... But the CNC is not moving at all. I have downloaded the firmware, made sure the drivers were up to date, done all I know to do. Any other suggestions ?
Senior Member
All are not moving? Check the power supply to the drivers
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein
Member
Its all good. when I attached the usb control card to the main card, I did not re attach the main card to the drivers assuming i would have to tear into it.... replaced like it should be, restart... and boom....
Posting Permissions
Reply With Quote