Sounds like you have a bad connection or a pinched / half broken wire. Maybe - turn off power, unplug and reseat all connections, check each wire for damage / half broken wires paying close attention at the connectors.
Sounds like you have a bad connection or a pinched / half broken wire. Maybe - turn off power, unplug and reseat all connections, check each wire for damage / half broken wires paying close attention at the connectors.
Tim Lucas Custom Woodworks
www.TLCW.us
I'm going to order a new main board tomorrow. I just have a feeling something is wrong with this one. I've been checking connections, all seems ok, but it wouldn't be hard to over look the slightest one
I have had a half broken wire at a connector that is why I suggest a carful look
Tim Lucas Custom Woodworks
www.TLCW.us
You could send the board in and they will check it and repair if needed
Yea. I'm just going to order a new one. The thing is, I have a big craft show this weekend. And very little product lol.
I feel since I have updated to the most recent software, that the machine is not coenciding with it?
Yes. Several times to.make sure I done it right. Progress bar apperas, and then goes away when it is complete
I guess I should note, the Z axis seems to be doing just fine. But let's say if I'm moving the X axis, and it starts to jerk, the Y axis will then jerk....so once one axis starts to jerk.... theY both jerk.
Should I be looking at any Limits, or ramp values Etc? Or should I go back to the old software?