Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Adirondack Chair out of plywood?

  1. #11
    Join Date
    May 2011


    I worked years ago at a company designing teak outdoor furniture, teak is extremely expensive unless you are buying tractor trailer loads. White oak holds up extremely well, I have had good luck with sapele outdoors too.

    The Adirondacks pictured are white oak the lighter ones and sapele. the other furniture is sapele for the back patio of our library. No finish is needed on these woods I did coat the Adirondacks with sikkens

  2. #12
    Join Date
    Feb 2013
    River Fall WI


    We do it all the time out of ACX 3/4" ply, works great, just make sure to prime, paint and seal the bottom of the legs with some ploy glue.
    Kyle Stapleton
    River Falls Renaissance Academy
    Math/Technology Education Teacher

    PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
    Desktop w/spindle
    Potter Pen
    Aspire 8.5, Creo 3.0

  3. #13
    Join Date
    Mar 2006


    If you want to make one out of plastic here is the cheapest
    Attached Images Attached Images
    Words of Wisdom:
    “Words that sink into your ears are whispered…… not yelled”
    “The biggest trouble maker you’ll probably ever have to deal with, watches you from the mirror every morn’n”
    “The only difference between a rut and a grave is the depth”
    Just remember...when it's time for the hearse to pull up..there's no luggage rack on top!
    The beauty of the Second Amendment is that it will not be needed until they try to take it...Thomas Jefferson

  4. #14
    Join Date
    May 2014


    Wow! This is an awesome set of responses! Thank you everyone!

    I might give this a shot out of MDO... I've been wanting to try that stuff out for a while and this seems like a good project to test on. I was looking for a way I could make something out of a sheet good, pull it off the machine and assemble with some stainless fasteners. It seems like the only chance I have at that is using MDO, maybe some ACX.

    In reality, as many have suggested real solid wood would be the correct choice. If I were making these for a customer I would definitely do that. I could see planing down some boards and making a jig to do that...

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts