Hey all, I've got a job coming up where I have to drill into the endgrain of a LOT of rectangular pieces that I'm cutting out on the ShopBot.
I've got a PRS 48x96 and I've got my table setup so I can travel several inches past the end (X 103 I believe)
I need to mount material vertically under the spindle in a repeatable way so that I can do all of these drillings accurately (and quickly)
I'm planning on building something out of 8020 or similar extrusion. I know others have done this sort of thing and I'd be curious to see your setups!
2018-01-11 at 9.41 AM.jpg