Hello all. Wondering if there is a setting I can modify for this. I've searched the archives to no avail. Trying to make an mdf Shaker style door. I used to get pretty clean corners with "Free Doors" before I got got into V Carve Pro. Using a 90 degree bevel bit and the inside profile with the square corner option. The tool "over-cuts" the corner in the M3 move. I've tried editing the bit setting from 80 degrees to 110. Under 90 gives straight a straight line segment over-cut corner. Over 90 and it starts to do a rounded over-cut. FYI, Alpha, spindle, 3mm per pass to 6mm deep, 8k rpm at 20mm/sec. Any thoughts are appreciated. Thanks.