New shopbot desktop owner here, planning to upgrade to a max in the future but loving the desktop for now! I build guitars and have a question in regards to tiling a guitar neck vs doing the machining on a diagonal plane. Especially since the back of the neck will be a 3d carve I'm wondering if this will be too much strain on the machine rather than just using the x axis and doing the headstock first and then the rest of the neck after moving? For reference a neck is about 26" long, barely too long to fit on the machine bed but it can fit in between the rails in the X axis. I'm thinking that one of these options is better than using a pass through on the y since then I would have to stop the 3d operation somewhere in the middle of the neck carve. Let me know what you guys think, and as always thank you!