Resister for Gecko drive G203V

[jerry_stanek]

When you say it was the driver did you call Gecko. I had one fail and they walked me through it and said it was the little green resister and they shipped me out 2 of them free. They are very good and said that the drives normally don't go bad. The resister just plugs in I didn't have to do any soldering. It has been running fine for over a year now.

[Brady Watson]

Most of the time with the G203 drives, there is a bad connection between the screw terminals and the studs on the board. All you need to do is pull the drive and screw terminals and reseat the drive. The G203 is called the 'vampire' drive because it is hard to kill. I doubt the drive is bad.

-B

[Burkhardt]

Most of the time with the G203 drives, there is a bad connection between the screw terminals and the studs on the board.....

Oh yes, had that happen with 3 of my five G203V, very annoying. I guess the silver plated contact surfaces oxidize or maybe the terminal side contacts lose spring force. Just unplugging and re-plugging helped but not reliably. Therefore I pinched the studs with a sharp side cutter to create several ridges and that did the trick so far. If that happens again I may remove the pluggable terminal blocks and solder the wires directly to the studs.