Just updated my software now x, y & z move wrong distance. when 10" is entered x & y move ~7.375" It's aprox. 30" short over length of 105" table. How do I fix this?
New Member
calibration
Just updated my software now x, y & z move wrong distance. when 10" is entered x & y move ~7.375" It's aprox. 30" short over length of 105" table. How do I fix this?
Senior Member
Load the correct settings for your model of machine
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein
New Member
Thanks, pretty sure that's what I did, PRSalpha 96x48 but obviously something didn't work right. Supposedly the unit values were provided in machine documentation but I sure can't find it. I could try a different machine setting file but I don't know how to get there...Originally Posted by Gary Campbell
New Member
alright never mind I fingered it out, thanks for your help, jerry
Reply With Quote
