I finally have the money, the time and the place!
Looking to buy a smaller footprint Shopbot!!
PM me or email
Mark@
mdebruce (at) yahoo.com
Thanks!
I finally have the money, the time and the place!
Looking to buy a smaller footprint Shopbot!!
PM me or email
Mark@
mdebruce (at) yahoo.com
Thanks!
I'll post when I buy something so until then I'm your huckleberry!
LOL
I’m going to put my desktop up for sale. It has 1 hp spindle, digitizer, several bits, original vsoftware, vcarve. The machine has been hobby use only and has very few hours on it. I’m located in Albuquerque, NM and will sell for pickup only, That might be negotiable. I’ll work up a fair price and get back to you.
Getting close to buying a machine. Looking at used machines. What year was the last major improvement of the desktop?
hi claimbuster, if you are looking for a buyer who will pickup we are in the market for what you have. we are located in downtown albuquerque and deal in cash. please keep us in mind!!
john@healeyfineart.com
respectfully yours,
john
The beginning of August 2017 is when the Desktop received the design update with two Y axis drive motors and frame improvements
Some of the differences can be seen in the pictures in each Quick Start Guide -
QS Guide for DT's from before August 2017 - http://www.shopbottools.com/ShopBotD...StartGuide.pdf
QS Guide for DT's from August 2017 and later - http://www.shopbottools.com/ShopBotD...hipAug2017.pdf
-Tom
Just to add a little on older Desktops...The transition from 4"Z to 5.5" was approximately April 2015.
We upgraded our two Desktops with the kit from Shopbot for around $275 each, and it takes a couple hours.
A quick giveaway of 4" Z is the dust shroud for spindle models...upgrade Z plate doesn't allow it to be used.
Couldn't find an exact pic, but similar to this pic except open on the top, and hinged to swing open to the left.
1.5" Z doesn't sound like much...but it IS
scott
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
I've got a desktop, thanks for help!
Congrats Mark!
What did you wind up getting?
Keep your finger near the Spacebar
scott
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine