Has anyone cut this stuff?
I think its two bit process .250 end mill and a v bit to finish.
Just looking others experiences.
Thanks
Mark
Has anyone cut this stuff?
I think its two bit process .250 end mill and a v bit to finish.
Just looking others experiences.
Thanks
Mark
There has been a mix. It cut like butter for me but for Mark D. it was a nightmare with chipping and horrible cuts. We used basically the same bits and feed and speeds. I know "Sometimes its good" is not what you wanted to hear. But forwarned and all that.
"Once a person moves away from the computer and CNC some of the most important work begins." ~Joe Crumley
what feed and speed are you using?
I used a 2 flute endmill 4in/sec @ 13K .125 passes
"Once a person moves away from the computer and CNC some of the most important work begins." ~Joe Crumley
thank you sir.
Ill give it a run.