Made this case to showcase my kitchen utensils.
It folds up to a size that fits in my display trailer shelf. Made out of hemlock its reasonable light and strong, the legs are red oak.
Made this case to showcase my kitchen utensils.
It folds up to a size that fits in my display trailer shelf. Made out of hemlock its reasonable light and strong, the legs are red oak.
That's awesome! What did you design it in?
Eric,
Your suggestion for feeds and speeds are about right.
I'm thinking the problem is the bit. Onsrud is my choice. I use VCarve Pro. Perhaps he should visit Vetric, Vcarve Pro and post over there.
Joe
Last edited by joe; 07-11-2018 at 08:09 AM. Reason: Inclusion of Photo
Wrong thread Joe.
I should have been more specific, what CAD program did you design it in?
By cut and fit do you mean you cut it on your shopbot or by hand?
Splendid. Thanks for posting.
Gotchya. That's what I figured. Are you using CAM in solidworks or are you exporting to Vectric and then making tool paths (obviously for the ShopBot made parts)