-
Eric, these are the ones I ordered. I just clicked on the firsts ones I saw.
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1
Brady, I am a miser at times. I planned to make some eccentrics on the lathe. Chuck the stock up off center a tad, drill a hole, then re-chuck and turn to size. I planned to make the washer part of them large enough to put a couple flat spots on them so I can adjust them & Hold them while tightening the nut. Might work might not, but I'm always up for an adventure.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules