After reading all the good things about the Amana 2250, I decided to order one. My question is, when drawing the tool in Vectric, do you just draw it with a 1.5" head, or do you draw the actual cutters on it?
Thanks in advance for any help
After reading all the good things about the Amana 2250, I decided to order one. My question is, when drawing the tool in Vectric, do you just draw it with a 1.5" head, or do you draw the actual cutters on it?
Thanks in advance for any help
Enter it as a 1.5" endmill.
Gary Campbell
GCnC Control
GCnC411(at)gmail(dot)com
Servo Controller Upgrades
http://www.youtube.com/user/Islaww1
"We can not solve our problems with the same level of thinking that created them"
— Albert Einstein