Results 1 to 8 of 8

Thread: Seahorse in Limestone

Threaded View

  1. #1
    Join Date
    Mar 2005
    Location
    San Jose, CA, USA
    Posts
    685

    Default Seahorse in Limestone



    At my first Camp Shopbot there was discussion about working with marble and limestone. Thirteen years later I'm still enjoying these types of projects.

    Roughing pass with a 1/2" ballnose bit at 15% stepover.
    Finish pass with a 1/8" ballnose at 7% stepover.
    The carving is about 12 inches tall and about 0.4" deep
    Attached Images Attached Images
    Last edited by rcnewcomb; 09-15-2018 at 05:56 PM. Reason: typo correction
    - Randall Newcomb
    10 fingers in, 10 fingers out
    another good day in the shop

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •