Trying to post my first message. I typed a long one this morning but it isn't showing up so will keep this one brief.
Rich
Trying to post my first message. I typed a long one this morning but it isn't showing up so will keep this one brief.
Rich
Rich Ahrens
Building Character
Charlotte, Vermont
Hello Rich…
I’m sorry your first post didn’t work as expected, perhaps long posts aren’t allowed in the test area. At any rate, Please try again!
SG
Steve,
I tried again to another section specific to cutting and technique but it says my post needs to be approved by a moderator. Any idea how to contact the moderator so I can ensure my thread gets posted?
Rich Ahrens
Building Character
Charlotte, Vermont
GRRRRR…
The “needs approval” glitch is something that occasionally raises its ugly head!
What I do is just immediately repost… usually that solves the issue. If you have a question you’d like an immediate response to, feel free to send me a PM (private message). Or Email me at steve.glassel@sgmfg.com.
Super moderator Bill young… I haven’t had this issue in a while, but maybe you could see if there are several trapped messages?
SG
Bill.....MENTION it to Richard.Hill that followed through on this glitch the last time...He's probably the most familiar with it from last time.
scott
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
Thanks, Steve.
I just posted again and the message appears to have taken this time. The same thing happened the other day when I tried to post my first thread in this section.
Rich Ahrens
Building Character
Charlotte, Vermont
Handibot ………...
Just trying to see how this works