I have to make a ton of balusters, each with 4 chamfers 1-3/6 inch wide and deep. Can I use a big router bit in the shop bot?
I've used this bit on my router:
"uxcell 1/2 Inch x 1-1/2 Inch Carbide Tipped 2-Flute 45 Degree Chamfer Router Bit Cutting Tool"
It has a 1/2" shank, 1.5" wide chamfer, unknown chip load. Can I use that on a shopbot? I've used it in my Bosch router quite a bit and I think that is higher than 18kRPM.
What about plunge cove router bits? like a 1/2" plunge cove? Or even bigger? Do I just start slow and test speeds? Thanks!