Results 1 to 2 of 2

Thread: VFD not turning on/not lighting up, spindle not turning on.

  1. #1
    Join Date
    Mar 2018
    Posts
    1

    Default VFD not turning on/not lighting up, spindle not turning on.

    Hello,

    We have the PRSAlpha and the VFD is not turning on/lighting up. Just cut a few letters and after loading the next set to cut, tried to turn the spindle on and nothing happened; noticed the VFD was not lighting up. I looked everywhere and people mentioned the contactor might be stuck so we turned off everything, opened the control box, and pressed the contactor. Turned the machine back on but VFD is still off. Didn't hear a click either but the contactor didn't seem stuck...
    IMG_0691.jpg
    Here's a picture of the contactor. The middle part was the only pressable part of it.

    This hasn't happened before so we don't know what to do. It worked and then a minute later it didn't.

  2. #2
    Join Date
    Mar 2004
    Location
    Delray Beach, FL
    Posts
    3,708

    Default

    Just to make sure, did you check the breaker, any plug from box to outlet?
    Do you have a tester to check the power feed lines? If not, you should. Start there and then work in.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •