Results 1 to 3 of 3

Thread: Aircut/Jog Home

  1. #1
    Join Date
    Nov 2018
    Posts
    1

    Default Aircut/Jog Home

    Hey there. I have a 48-48PRS-standard shopbot, and I haven't had issues with the jog home or aircut until now. The last cut I did, we adjusted something from the z axis height when it jogs. Now as I'm trying to aircut a piece, it reaches a limit of height and does not function. I'm not sure how else to describe this situation, but I need to have something cut out. Any solutions?
    -Rebekah

  2. #2
    Join Date
    Apr 1999
    Location
    Rock Hill SC
    Posts
    475

    Default

    Did you somehow change the material setup to have the machine Z zero at the spoilboard surface instead of the material surface? Try to cut an older file that you know cuts OK.

  3. #3
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,683

    Default

    Did you zero the z axis "high" at some point and now the safe z height set in the software tries to take it higher and then tops out?
    Scott

    If guns kill people, I guess pencils misspell words, cars drive drunk and spoons make people fat.

    "Those who hammer their guns into plows, will plow for those who do not" - Thomas Jefferson




Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •