I have PartWorks 3.5 and I need to be able to use a different Post Processor than SBP. Is there a way to install different PPs without having to pay $500 to upgrade to Vcarve pro?
I have PartWorks 3.5 and I need to be able to use a different Post Processor than SBP. Is there a way to install different PPs without having to pay $500 to upgrade to Vcarve pro?
The reason you are able to get a discounted rate on the SB version of the software is because it only supports ShopBots!
To upgrade the current version of ShopBot VCP to be able to run other brands post processors is a $500 fee.
SG
Depending on what you're doing you can either upgrade, or take a look at Fusion 360. It's free if you're a hobbyist. It's more meant for metal mills, but it's got some pretty incredible toolpathing in it.