Looking for a router bit

[srwtlc]

Has anyone seen this profile in a router bit? Material shown is 5/8", but will be done on 3/4", and the offset is approximately 5/16". Preferably with guide bearing. Not having much luck locating one. Might just have to use a ogee, but those are generally more offset with larger radius.

[coryatjohn]

An edge profile would be more meaningful.

Often, the right profile can be achieved by using multiple bits.

[srwtlc]

Yeeeah, thus the picture....

Multiple bits isn't going to yield this, but will yield more cleanup time.

Disregard anyway, customer changed their mind, again.

[Brady Watson]

Disregard anyway, customer changed their mind, again.

Lies...this never happens!

[srwtlc]

I know, who'd a guessed it!