Results 1 to 9 of 9

Thread: fan for yaskawa v7-4x fan vfd?

Hybrid View

  1. 03-28-2019, 07:49 PM #1
    knight_toolworks's Avatar
    knight_toolworks
    knight_toolworks is offline Senior Member
    Join Date
    Sep 2006
    Location
    cnc routing, portland or
    Posts
    3,633

    Default fan for yaskawa v7-4x fan vfd?

    I have noticed the fan on mine is louder. hey only 12 years old so no complaints.
    Reply With Quote Reply With Quote
  2. 03-29-2019, 02:51 PM #2
    Martin Reid's Avatar
    Martin Reid
    Martin Reid is offline Member
    Join Date
    Nov 2012
    Location
    Lancashire, UK
    Posts
    66

    Default Manual error displays

    Dear Steve

    You can find the manual online..

    https://www.yaskawa.com/delegate/get...e=TM.V7.01.pdf

    Table 6.2 shows the Fault Displays..

    Sincerely
    Martin
    Reply With Quote Reply With Quote
  3. 03-29-2019, 04:48 PM #3
    knight_toolworks's Avatar
    knight_toolworks
    knight_toolworks is offline Senior Member
    Join Date
    Sep 2006
    Location
    cnc routing, portland or
    Posts
    3,633

    Default

    ya found the manual but no fans in the US. I found the fan pops out without taking it apart.so I will try cleaning it.
    Reply With Quote Reply With Quote
  4. 03-29-2019, 06:37 PM #4
    Brady Watson's Avatar
    Brady Watson
    Brady Watson is offline Senior Member
    Join Date
    Jan 2004
    Location
    iBILD Solutions - Southern NJ
    Posts
    7,986

    Default

    Usually the plastic grill under the fan vibrates...

    All those fans are standard sizes. Check the voltage probably 24v. Measure the bolt pattern and thickness. Then find another generic one.
    High Definition 3D Laser Scanning Services - Advanced ShopBot CNC Training and Consultation - Vectric Custom Video Training IBILD.com
    Reply With Quote Reply With Quote
  5. 03-29-2019, 06:44 PM #5
    knight_toolworks's Avatar
    knight_toolworks
    knight_toolworks is offline Senior Member
    Join Date
    Sep 2006
    Location
    cnc routing, portland or
    Posts
    3,633

    Default

    ya I will take it off when I am done today and clean everything. hey its 12 years old with lots of dust running through it it has lasted well.
    Reply With Quote Reply With Quote
  6. 03-30-2019, 12:02 AM #6
    knight_toolworks's Avatar
    knight_toolworks
    knight_toolworks is offline Senior Member
    Join Date
    Sep 2006
    Location
    cnc routing, portland or
    Posts
    3,633

    Default

    well it is a oddball 60mm x25mm 24v but 3 wire plenty of two wire ones but hard to find all those
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules