Hello everyone,

Please join ShopBot Tools this Thursday May 9th for a free online training. The topic this week is “Starting Points & Z Heights.” The training begins at 1:00pm eastern time and runs approximately 45 minutes. It is then followed up by a 45 minute Q & A for participates to ask questions and work with each other.

This training will show you how to optimize your start/finish points and safe Z heights. By default the software returns to 0,0 at the end of the cut, we will show you how to setup custom start and stop locations. We will also look at setting up safe Z heights to optimize cut times and safely move your bit around without running into any obstacles. These are some great practices for operators to become more efficient.

There is no need to sign up, just show up a few minutes early on Tuesday and click on the link below. You will log into GoToMeetings and wait for the training to get started. Make sure your computer volume is turned on.

If you have any other questions please feel free to shoot me an Email. This training will be recorded and posted for future viewings. Those recordings can be found on our ShopBot Tools Training Page.

Thanks and hope to see you there. Thanks, TJ

Starting Points & Z Heights
Thu, May 9, 2019 1:00 PM - 3:00 PM EDT

Please join my meeting from your computer, tablet or smartphone.
https://global.gotomeeting.com/join/569447213

You can also dial in using your phone.
United States: +1 (872) 240-3212

Access Code: 569-447-213

Joining from a video-conferencing room or system?
Dial: 67.217.95.2##569447213
Cisco devices: 569447213@67.217.95.2

New to GoToMeeting? Get the app now and be ready when your first meeting starts:
https://global.gotomeeting.com/install/569447213