I was excited to try out the Box Creator (v1.1), but alas the Square Tabs I profiled were way off. I wanted two inch square tabs, but the tabs came out 2.25" and the receiver space was only 1.75". Glad I practiced on baltic birch...

I was confused when I selected the vectors to profile, since the CutOut layer has an outer vector (with arrows) and the Box Layer has the vector that I assumed would be THE box parts. Normally when I profile, I am used to choosing a single outline, So I ignored the CutOut layer vector and only profiled the Box layer vectors, choosing to cut outside the line.

After my failure, I looked at the vectors again, thinking I needed to choose the CutOut layer vectors only, but they don't seem to fit when I scoot them next to each other in Aspire. I used a 0.25 inch EM and did an Allowance Offset of the radius (0.125)

Thanks if someone can help me see the error of my ways.