Box Gadget: I'm confused by the vectors for profiling ('Box Layer' vs CutOut Layer)

[carolinasmith]

Thanks Scott,
I installed Fingermaker. It looks more daunting, but I will check it out... I can't remember if it has sharp angles on the mortises and tenons, I think it might.

[scottp55]

READ Gert's DETAILED instructions!!!

He Beta tested it on this Forum, and does seem daunting, but a lot of that is because of all the options
If a Brand Newbie like I could do it 4+ years ago..then you can!

Keep meaning to get back into it, but things keep coming up(REMEMBER....Bit cuts using a LOT of cutting edge, make sure you have enough on your straight Ball Nose....AND bit will go into spoilboard the radius of the Ball Nose,so adding a separate carrier board is not a bad idea!)

Maybe G. will chime in?
I can't remember about square fingers

scott

THANKS Dan!! Too bad I have an old Desktop with a single Y-screw in the middle!

[tri4sale]

THANKS Dan!! Too bad I have an old Desktop with a single Y-screw in the middle!

Makes me want to go buy a Desktop Max!!! But at least they say this "This accessory can also be used with our larger gantry model tools by modifying the table bed, creating a slot so that material can be mounted vertically on the front face of the jig." just wondering what is involved in "modifying the table bed"