Nice timing, they actually posted on Facebook yesterday that it's been released
https://store.shopbottools.com/produ...dhLI2wVMHQ7TCs
It's been added to my Christmas wish list
Nice timing, they actually posted on Facebook yesterday that it's been released
https://store.shopbottools.com/produ...dhLI2wVMHQ7TCs
It's been added to my Christmas wish list
Daniel E.
ShopBot PRS 48x96 (2010 Model)
Porter Cable Router
Vacuum Table w/ 2 Fein vacs
Aspire 9.0
What I do when I don't mess up wood: http://www.pathhome.net
Thanks Scott,
I installed Fingermaker. It looks more daunting, but I will check it out... I can't remember if it has sharp angles on the mortises and tenons, I think it might.
ShopBot Desktop MAX, spindle, 3" Indexer, Aspire 9.5, and a big learning curve...
READ Gert's DETAILED instructions!!!
He Beta tested it on this Forum, and does seem daunting, but a lot of that is because of all the options
If a Brand Newbie like I could do it 4+ years ago..then you can!
Keep meaning to get back into it, but things keep coming up(REMEMBER....Bit cuts using a LOT of cutting edge, make sure you have enough on your straight Ball Nose....AND bit will go into spoilboard the radius of the Ball Nose,so adding a separate carrier board is not a bad idea!)
Maybe G. will chime in?
I can't remember about square fingers
scott
THANKS Dan!! Too bad I have an old Desktop with a single Y-screw in the middle!
scott P.
2013 Desktop/spindle/VCP 11.5**
Maine
Makes me want to go buy a Desktop Max!!! But at least they say this "This accessory can also be used with our larger gantry model tools by modifying the table bed, creating a slot so that material can be mounted vertically on the front face of the jig." just wondering what is involved in "modifying the table bed"
Daniel E.
ShopBot PRS 48x96 (2010 Model)
Porter Cable Router
Vacuum Table w/ 2 Fein vacs
Aspire 9.0
What I do when I don't mess up wood: http://www.pathhome.net