Results 1 to 2 of 2

Thread: Door construction

  1. #1
    Join Date
    Jul 2004
    Location
    Corpus Christi, Texas
    Posts
    44

    Default Door construction

    Hello all,
    I need to make a couple of doors with carving on the panels. A large panel in the top and bottom. If I make the stiles and rails 1 3/4 or 1 5/8 thick, would the panels be ok at 3/4 inches thick be ok. They will be interior doors.
    Burning up in south Texas.
    Thanks,
    Mike

  2. #2
    Join Date
    Dec 2008
    Location
    Diamond Lake, WA
    Posts
    1,620

    Default

    3/4" panels would be fine. Just make sure you set them in dados in the rails and stiles. Very similar to making cabinet doors. Use space balls or some other rubber type of insert to keep the panels from rattling around. The big difference is the strength of the construction needed to keep the doors from racking once mounted. I use the Domino and multiple 5" long tenons to reinforce the rail and stile coping. There are industry standards for rail and stile width and panel sizes to keep them looking nice and accommodating hinges and door knobs. If you are going to stain, I'd stain the panels before you assemble the door so that as the panel shrinks and expands you don't get lines showing.
    Don
    Diamond Lake Custom Woodworks, LLC
    www.dlwoodworks.com
    ***********************************
    Life is not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece; But to skid in broadside, thoroughly used up, worn out, bank accounts empty, credit cards maxed out, defiantly shouting "Geronimo"!

    If you make something idiot proof, all they do is create a better idiot.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •