Hi There and thanks so much for any advice you can offer

I'm cutting a fairly large 3D shape (on a tight deadline!) that has a height of 12". I have sliced the model in Apsire and plan on doing it in 4 3" thick slices.

Looking for feeds and speeds, and any suggestions of how to get this done ASAP!

Only 1/2 of the model will fit on the 4x8' bed, so it has been also been split down the z axis. I anticipate a busy week next week!!

Ordered these bits which I hope will suffice:

Amana 46277 Solid Carbide Foam Cutting Up-Cut Spiral 3/8 Dia x 4 Cut Height x 3/8 Shank x 6 Inch Long Flat Bottom Router Bit

Amana Tool 46032 Solid Carbide Foam Cutting Up-Cut Spiral 1/8 Radius x 1/4 Dia x 2-1/4 Cut Height x 1/4 Shank x 4 Inch Long Ball Nose Router Bit

Thanks so much!

base half.jpg