-
Switching control computers
I need to change the control computer. Is there a way to save the current software from the old computer so I do not have to set up the table area again. Meaning reset the home position 0 0 on the new computer.
Tracy Spitulski
KenCraft Co Inc.
PRSa 6096
www.kencraftcompany.com
Hardwood Lumber, Custom Millwork
Dust Collector Fittings
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules