What is your hold down method? Sounds like your material is moving up and down.
Senior Member
What is your hold down method? Sounds like your material is moving up and down.
Kyle Stapleton
River Falls Renaissance Academy
Math/Technology Education Teacher
PRS Alpha 96x60 2.2 hp spindle, Double Air drills, 6" indexer, Fein 5 zone vac table
Desktop w/spindle
Potter Pen
Aspire 8.5, Creo 3.0
Member
I have a vacuum system, so it's definitely not that. I even leave of dust collection so that it's not fighting the vacuum. I also recently skimmed the spoilboard.
It seems to happen when leaving the software to generate the toolpath, and then it sometimes has the z-axis go up, move, go down, and the clear a small portion.
Reply With Quote
