I had a couple questions about Cabinets Parts Pro. I have not downloaded the trial version. But I think I have watched all the videos.

1- I am curious if this works for face framed cabinets? I haven't seen anything about your program and face frames.

My assumption is if I had a 30" wide cabinet, and wanted ½" of scribe on both sides, I would cheat and tell the program it was a 29" cabinet?

2- Can I specify one side of the cabinet being a finished end/different material? If I have a 30" wide faced frame cabinet with ½" of scribe on the left and a smooth finished end on the right, can I tell the program I want a 1 sided melamine/ 1 side veneer on the right side of the cabinet only? Or eliminate a side completely if I was doing a paneled side?

Thanks, Mason