-
Looking for a Shopbotter that can help me get a plasma cutter up and running - PA.
I am an avid Shopbot guy and understand mine well enough to get by with mine just fine using Aspire and the Shopbot Control software.
I recently purchased a cnc plasma setup that has never been set up. Hoping to find someone that would know enough about this to help me get it going as well as my Bot! Its mostly assembled but not yet running. I'm in South Central PA but I could load it all up and bring to you if willing to help within reasonable drive.
The details of what I bought are as follows...
Dragon Cut-300 w/digital current probe,raw arc voltage
control,and the basic 2D plasma software bundle
Precision Plasma 4 x 4 DIY gantry kit w/ Z upgrade
Hp desk top unit ,custom computer.plasma powersource roller stand
Hypertherm Powermax 600
Hypertherm machine torch w/remote pendant
This cutting table was custom built and the water table is larger that 4'x4' which allows for full space utilization.
Also included is all of the manuals, cds and the computer system.
John 717-sevn-too-9-4138
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules