Just purchased a used ShopBot and not going to use the vacuum that came with it. Anyone ideas on this and what it may be worth?
Just purchased a used ShopBot and not going to use the vacuum that came with it. Anyone ideas on this and what it may be worth?
What's the electric motor rated at? 220v? 1 phase? 3 phase? Hard to tell anything from the information provided. I suspect it's not adequate for use with the Shopbot.
ShopBot Details:
2013 PRS 96x60x12 (Centroid upgrade)
4hp Spindle
12" indexer
Aspire
Rhino
Fusion 360
Ferrari 360
Prusa MK3S+
Prusa XL multi-tool
Here’s the specs on the blower that I found online…
33 AF ROOTS BLOWER
Category: Roots AF Rotary Positive Blowers
This product has been discontinued.
The AF Series has been discontinued and replaced by the Universal RAI blower series.
The 33 AF is typically replaced by the 33 URAI model
Product Description
Roots model 33 AF Blower
Flow Range: to 91 CFM
Max ΔPressure: 6 psi
Max ΔVacuum: 10″ Hg
Maximum Speed: 1850 RPM
Minimum Speed: 1090 RPM
Max ΔT: 190° F
Connection Size: 2″
Shaft Diameter: 0.6562″
Drive End Lubrication: Grease
Gear End Lubrication: Oil
Required Oil for Gear End: 6 Fl Oz
Unit Weight: 95 lb
The Roots rotary blower AF Series are now obsolete, replaced by the Universal RAI series. The 33 AF blower is typically replaced by the 33 URAI blower. Comparing these models, the inlet size, mounting feet diameter, and speed are the same, but the shaft size has changed from 0.6562″ on the 33 AF to 0.750″ on the 33 URAI.
The AF Series were standard duty units suitable for either pressure or vacuum service. The basic model is suitable for rotation in either direction consisted of a grey iron casing, alloy steel gears, grey iron impellers and anti-friction ball bearings. The unit has splash oil lubrication on the gear end and grease lubrication on the drive end.
By today’s standards, these units were operated very slow and were limited in maximum allowable pressure and vacuum.
Essentially, a nice door stop.
ShopBot Details:
2013 PRS 96x60x12 (Centroid upgrade)
4hp Spindle
12" indexer
Aspire
Rhino
Fusion 360
Ferrari 360
Prusa MK3S+
Prusa XL multi-tool
‘Essentially, a nice door stop’
For some people, yes. It won’t hold down 8” X 8” parts but likely could be finessed into holding cabinet sides and doors!
SG
Ah ok thanks guys! My guess was as much. If anyone has a need for it or wants to trade anything at all for it, let me know. Im ordering the Becker Rotary Vane Vacuum Pump from ShopBot tomorrow.