Results 1 to 1 of 1

Thread: PrismCarve cutout

  1. #1
    Join Date
    Sep 2008
    Location
    Tam Arte Design Studio, Downingtown PA
    Posts
    117

    Default PrismCarve cutout

    Hi all,
    Been many years since I've been on the forum. Business slowly died off for the ShopBot for signmaking (business shifted elsewhere for graphics), but I wanted to get back into playing with the machine just for myself. I've upgraded the control board to V4G and have the VCarve Pro 10.0. I was playing with it today, getting all the variables set up and getting back into practice. I set up a very simple file for FCO's, V-carving and prism carving with a single letter. I noticed that, when doing the prism carving (1" V bit into 3/4" pvc) and cutting the exact same outline with a 1/4" end mill that it's not exact - the "cutout" is shifted about 1/16" to one side. I don't recall that happening with the older control software but it may have.. I just don't recall. Now, I can simply inline the image by 1/16 and be done with it, but I'm sure there's a solution I'm not aware of.
    Any thoughts?

    Rick
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •