Today will look at how to create a VCarve drawing based on hand cut template and from a hand drawn sketch. Join us today at 1:00
Hand Drawn
Mon, Apr 6, 2020 1:00 PM - 2:00 PM (EDT)
https://global.gotomeeting.com/join/226307045
Today will look at how to create a VCarve drawing based on hand cut template and from a hand drawn sketch. Join us today at 1:00
Hand Drawn
Mon, Apr 6, 2020 1:00 PM - 2:00 PM (EDT)
https://global.gotomeeting.com/join/226307045
Sounds interesting Ryan
This time I'll make sure to start checking in early to make sure everything is working
scott
scott P.
2013 Desktop/spindle/VCP 12.0*
Maine
All about TRACING?
Our most important shop tool is the pencil sharpener!
Thanks for that yesterday Ryan
Always nice to watch someone else's drawing techniques when manually tracing an object, and then Node Editing shortcuts to Tweak it.
A lot different than me using short spans and Beziers right off the bat! I'll have to try your Arc technique!
Thanks,
scott
scott P.
2013 Desktop/spindle/VCP 12.0*
Maine
Are these going to be posted on YouTube? I can't take time during the workday to watch but would REALLY like to see them after work hours. Thank you!
Don
Diamond Lake Custom Woodworks, LLC
www.dlwoodworks.com
***********************************
Life is not a journey to the grave with the intention of arriving safely in one pretty and well preserved piece; But to skid in broadside, thoroughly used up, worn out, bank accounts empty, credit cards maxed out, defiantly shouting "Geronimo"!
If you make something idiot proof, all they do is create a better idiot.
Ryan mentioned a "2 sided machining" for tomorrow I THINK? It was for an air frame and wing airfoils for a EPF throw-type plane designed for Lift(?)
Just mentioning (as I don't know which "Wednesday" he was referring to, and my "Facts" seem to get worse with age
You guys can skip my show and tell sometime next week, on Tiny/Small 3Ds in branches and firewood
Looking forward to 2 sided machining Ryan!
More notice, and YouTube posting Would be good
scott
scott P.
2013 Desktop/spindle/VCP 12.0*
Maine
Yes more notice and youtube. What about an email for those of us that don't visit the forum as often as they used to. There should be an email database around there somewhere.
Thanks
Here is a link to some of the recording videos https://www.shopbottools.com/virtualworkshop More will be added.
You can see the upcoming live demos from this link. https://www.shopbottools.com/virtual...op#live-events