Results 1 to 2 of 2

Thread: FabMo & Raspberry Pi on a V4g control board

  1. #1
    Join Date
    Apr 2004
    Location
    Pearl MS
    Posts
    19

    Default FabMo & Raspberry Pi on a V4g control board

    Will a raspberry pi running FabMo control a PRT V4g board?

    Thanks.

  2. #2
    Join Date
    May 2014
    Location
    MA
    Posts
    610

    Default

    Check this thread:

    https://handibot.com/forum/read.php?2,3607

    They have posted Pi instructions:

    https://github.com/FabMo/FabMo-Engin...raspberry-pi-3

    I've tried those a few times and I got close, but I could never get it to work.

    You do need to have a motion control board connected for it to boot, and even then I wasn't able to get it going. I'm not that great of a developer though.

    It looks like they might have it working in Docker if you check their GitHub, although there aren't instructions. If Docker could work, it would be a lot easier to setup and deploy it.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •