Hi,

I am wondering if anybody has experienced latex paint not cutting on edges of a v carve? I attached a picture. The black latex paint I use cuts super clean but the blue for some reason just leaves bits behind. It made me thing that the black has a different latex base that is harder and maybe cuts or adheres better. It consistently happens on the blue.

I am using Amana insert V carve bits 60 deg at 40ipm 18000rpm. I have tried second passes, clear coating, as well as CMT laser point bit with no luck. I was thinking maybe I should change my paint to oil based or some other sign paint people might recommend?

Any input would be greatly appreciated!

CoryB0B0BE9D-C33A-4BD4-9B91-2EDA7147AA10.jpg